Team Associated ASC72212 DC10 Arm Mount Spacers

DC10 Arm Mount Spacers fine-tune suspension arm position on the Team Associated DC10 Drift Car and DC10 Classic platforms, letting racers adjust anti-squat, roll center, and arm angle without swapping entire suspension arms or mounts. Supplied as a set of four, these composite spacers fit between the arm mount and the chassis or bulkhead, shifting the pivot point slightly to change how the suspension geometry reacts under acceleration, braking, and weight transfer through a drift. Because drift setups rely heavily on precise geometry to control how and when the rear end steps out, small adjustments from spacers like these can noticeably change corner entry and slide consistency without the cost of new arms. They are molded for a snug, consistent fit against the factory mounting hardware, holding their thickness under repeated suspension loading so tuning changes stay put between runs. This is a direct-fit tuning accessory rather than a replacement for a broken part, intended for racers dialing in handling balance on either DC10 chassis variant. Keeping a spare set on hand makes on-the-fly geometry changes at the track quick and straightforward.